Earlier this year, I was approached by Rebecca to do the flowers for her wedding. I had done her sister's flowers a couple of years ago, and I was thrilled to be asked again. Rebecca's theme was lavender, and the wedding was to be held at a winery, so she wanted to incorporate those country elements in the design. Can you believe that she was hand embroidering 22 lavender bags - using no less than 3 shades of purple - to give to the female guests? It didn't take much to work out that she had a very keen eye for detail !!
I made a sample candle decoration. The candle was 20cm high, and had a woven structure around it, like a very small tray, upon which we could place the elements that she wanted: lavender, lichen-covered twigs, freesias (which would feature in her posy), grapes, and anything else that might take our fancy.
The sample one had Singapore orchids, grapes and lavender.
To make it I heated on the stove, short pieces of wire which I then embedded into the candle. Note: use pliers, the wire gets a bit hot. You need to have an odd number - there were 17 'spokes' in mine.
Then I wound long pieces of raffia under and over the spokes to the required radius of the base. I had found some purpley-grey cake stands onto which I was going to place the finished article, and they were about 20cm in diameter. I roughly joined the raffia pieces with a knot and left the ends loose, so that later I could tie the flowers and twigs to the base. I also didn't want it to look too sleek.
When it was wide enough, I tied the various bits and pieces on to the base, and then trimmed the ends. I finished the ends of the wire by slipping on a lavender bead, and then bending over the end of the wire to avoid any unfortunate finger piercings and subsequent tetanus shots at the reception.
The major change from Mark I candle was to use a taller cake stand, and make the raffia base at the bottom of the candle, rather than a couple of centimetres from the bottom.
I was really pleased with the result, and thought that it would make a great Christmas decoration, especially with some sparkly ribbon, or red raffia wound through. If you use the raffia base that is a bit higher, i.e Mark I, you could place the candle in a shallow bowl, and then poke real flowers through the base, so that they can drink water from the bowl.
Good idea ? I have to say that the original idea came from Master floral designer, Gregor Lersch, in his book "Floral Craftmanship", and I thank him for it.
